Engineered fall protection systems in New Mexico

Yes. Tritech designs, fabricates and installs as one team, and the drawings are PE-stamped. Your proposal names the engineering deliverables, the installation scope and the handover documentation, so there is no separate engineer to hire and no gap between the person who designed the system and the person who installed it.

It depends on the work and the standard that applies. For general-industry work, OSHA 1910.28 looks at how close the task is to the edge and, for some provisions, whether the work is both infrequent and temporary. Within 6 ft of an unprotected edge that generally means guardrail, travel restraint or fall arrest; the designated-area option from 6 to 15 ft only applies to infrequent, temporary work. Construction work by a contractor falls under 1926 and can differ. Review the actual task before choosing a system — when rooftop units or drains sit near the edge, as they do on most commercial roofs, the question usually settles itself.

New Mexico runs its own OSHA-approved state plan, New Mexico OSHA, which covers private and public workplaces. State plans must be at least as effective as federal OSHA and can set their own requirements, so the design is checked against the rule that applies in New Mexico.

Both have duties. A contractor is responsible for their own workers under 29 CFR 1926; you are responsible for your employees under 1910 and for giving contractors a workplace they can comply in. A permanent system designed for the roof is how most owners stop having that conversation every time a trade shows up, but the system has to fit the work each party actually does.

Guardrail is a barrier: nobody needs equipment or training to be protected by it. A lifeline is used with a harness and compatible connectors, so it depends on the user. Which one fits comes down to the work area, how much movement the job needs, what the structure can support and who will be up there. The site assessment compares the suitable options side by side.

It can if attachment and flashing are done without regard to the roof assembly. We review attachment details against the manufacturer’s requirements and use flashing details designed for the roof type; where a penetration is not acceptable we design around it. Send the warranty documents and your roofing contractor’s details early so any coordination is sorted before the crew arrives.

System length, structural conditions, engineering scope, attachment details, site access and installation restrictions. A guardrail run and a lifeline system for the same roof can differ several times over, so we do not quote ranges off a web form. Photographs and drawings define the scope; you get a real number and a project-specific schedule after the site walk.

Usually, yes. Send the manufacturer, the installation drawings and any inspection records you have. Whether a system can be inspected, repaired or recertified depends on its condition, its documentation and the manufacturer’s requirements — we tell you which of those applies before any work is quoted.

Yes. Summer rooftop installation is planned around the heat — early starts, water and shaded breaks — and materials and finishes are chosen for sustained sun and UV.

It is handled case by case — it depends on the site, the owner’s requirements and the contract. Speak with an expert and we will answer in detail for your project: call Wes directly, or send the site assessment request below and it will be covered on the first call.

Yes. Wes Hopkins covers New Mexico, including Albuquerque, Las Cruces, Santa Fe, Rio Rancho, Farmington, Roswell and Hobbs. Tell us the city and ZIP code of your facility and the site walk is planned from there.